Colloidal partical assembly machine
Colloidal partical assembly machine
Quantity:
1. The center of gravity of the electric tube rod pellet assembly machine and the total center of gravity of the working table and the foundation are located in the same vertical line with the centripetal force of the foundation.
2, the foundation of the large electric heat pipe rod pellet assembly machine should be pre-pressed before the machine device. The mass of prepressing is 2 times the total mass of the high voltage heat pipe rod pellet assembly machine and the sum of the larger mass of the customer's workpiece. The prepressed material can be steel, sand and small stones. The preloaded material should be evenly pressed on the foundation to ensure that the foundation sinks evenly. The preloading operation should be carried out until the foundation no longer subsists.
3, when starting the winding, whether beautiful or not, the winding point is too front or too back (there is no vertical phenomenon between the wire and the wound). The wiring is too thin or too dense (the wire diameter is set incorrectly). Both ends turn too fast or too slow (width set incorrectly: too fast = not wide enough, too slow = too wide). Whether the line is getting faster or slower with the coupling (then fine-tune the diameter of the line: faster = smaller, slower = larger). Pay attention to the coupling of the rows of wires after winding several layers. The object being wound changes shape after being wound multiple layers. The wire diameter marked on the enameled wire is the actual wire diameter, so it will be correct to add the thickness of the enameled wire when setting the wire diameter. After the winding is complete, the return (displacement) of the conductor also has an impact. Open the winding line, the winding point is recommended to move forward, and the width is recommended to narrow. Jumping and winding can generally be overcome in the setting method.
3, when starting the winding, whether beautiful or not, the winding point is too front or too back (there is no vertical phenomenon between the wire and the wound). The wiring is too thin or too dense (the wire diameter is set incorrectly). Both ends turn too fast or too slow (width set incorrectly: too fast = not wide enough, too slow = too wide). Whether the line is getting faster or slower with the coupling (then fine-tune the diameter of the line: faster = smaller, slower = larger). Pay attention to the coupling of the rows of wires after winding several layers. The object being wound changes shape after being wound multiple layers. The wire diameter marked on the enameled wire is the actual wire diameter, so it will be correct to add the thickness of the enameled wire when setting the wire diameter. After the winding is complete, the return (displacement) of the conductor also has an impact. Open the winding line, the winding point is recommended to move forward, and the width is recommended to narrow. Jumping and winding can generally be overcome in the setting method.
Colloidal partical assembly machineColloidal partical assembly machineColloidal partical assembly machineColloidal partical assembly machineColloidal partical assembly machineColloidal partical assembly machineColloidal partical assembly machine
Recommend Products
